STEP 3
STEP 4
11
Warning! Four adults
required for assembly.
Attach lower arms (#7) to Top Pole (#2), as shown in Figure 5, using a hex bolt (#H), four flat
washers, two lock nuts.
Attach upper arms (#6) to Top Pole (#2), as shown in Figure 5, using a hex bolt (#H), four flat
washers, two lock nuts.
Note:
Don't tighten bolt (#H) at this time. Tighten
bolts snug but, do not over tighten. Board
Arms must pivot freely.
The last bolt (#L) used as a stop bolt, through
this stop bolt into the middle hole and tight this
bolt as below:
Note: All board arms are made of rect-
angular tubing. Tightening hardware too
tight may damage tubing and make
adjustment of system difficult.
Note: To aid in the assembly of the
backboard afterwards in step 9, lower
the backboard, by turning the Actuator
Crank, until the lower arm makes con-
tact with Stop Spacer bolt (#H).
(Pre installed)
(Pre installed)
