Naxa NDC-402, Instruction Manual

Page: 8 / 29

7
4. Charge the camera for about 3 hours to get maximum battery power. Battery lasts as long as 2
hours under normal usage.
2.3 Using a SD/MMC/SDHC card
Turn your camcorder OFF before inserting / removing an SD Card.
Insert a memory card into the SD/MMC/SDHC card slot. Push it
down until the card stays latched. Do not force – check card’s
position according to the position mark on the camera.
To remove card, push card inward and it will pop out automatically.
- Note that the SD Card has a tiny LOCK switch on the side. Set the switch to the un-LOCK
position to store recorded videos and still pictures.
2.4 Powering on/off
In the power-off state, press and hold the power key to turn the camera on.
In the power-on state, press the power key to turn the camera off.
The camera will turn off automatically if it is on and left idle for 1 minute.
In power-on state, when the battery level is very low, the camera can turn off after several
seconds. You must recharge the battery when this happens.