
12
NAVMAN S100 User Manual
Speed Calibration
Speed Comparison Method
To adjust the speed displayed to match that of
another craft or the speed displayed on a GPS
receiver.
3 SEC
3 SEC
DISPLAY
To increase reading press the
key.
To decrease reading press the
key.
To enter the calibration setting into memory and
exit press the
key.
Log Calibration Method
Set your log to zero and travel a known distance
between two points.
If there is any tidal current,
you should travel the same course in both
directions to find the average distance.
You may calculate a correction factor as follows:
Known distance
correction factor =
distance from log
For example, if you have travelled over a known
distance of 1 mile but your log reading is 0.8,
giving a correction factor of 1.25. Therefore, your
correct boat speed will be the indicated speed
multiplied by 1.25.
Enter the simulation mode by holding the
key
at power up, When speed is selected in the
simulator mode the display will indicate a fixed
calibration speed, for example 10.0 knots.
Follow the Secondary Functions chart to reach
Speed Calibration mode.
Use the
to set the displayed speed to the
new value. For our example, this new speed
would be 10.0 x 1.25 which is 12.5 knots.
To enter the calibration setting into memory and
exit press the
key.
To exit simulation mode, remove the power and
then hold the
key at power up.
Summary of Contents for S100
