Version 28.02.2023
HW:CAM (V100)/(V23)
RL4-SC15
P
a
g
e
5
1.4.
Settings of the 8 Dip switches (black)
Some settings have to be selected by the dip-switches on the
video interface. Dip position down is ON and position up is OFF.
*
The front camera
will only be switched
automatically
for 10 seconds after disengaging the
reverse gear,
if dip6 is also set to ON
(see following information).
After each Dip-switch-change a power-reset of the Video Interface has to be performed!
See the following chapters for detailed information.
1.4.1.
Activating the front camera (dip 1)
If set to ON, the interface switches for 10 seconds from the rear-view camera to the front
camera input after having disengaged the reverse gear. In addition, a manual switch-over to
the front camera input is possible via keypad (short press) from any image mode. The
selection of automatic or manual front camera switching is controlled by dip6.
Description of the front camera Power supply: see chapter "Power supply output".
1.4.2.
Enabling the interface’s video inputs (dip 2-3)
Only the enabled video inputs can be accessed by switching through the interface’s video
sources. It is recommended to enable only the required inputs. So the disabled inputs will be
skipped while switching through the video interfaces inputs.
Dip
Function
ON (down)
OFF (up)
1
Front camera
enabled
*
disabled
Power supply output
(red wire)
+12V (max. 3A) when reverse gear
is engaged incl. 10 seconds delay
and +12V by manual switching to
front camera by keypad
+12V (max. 3A) ACC
2
CVBS AV1-input
enabled
disabled
3
CVBS AV2-input
enabled
disabled
4
No function
set to OFF
5
Rear-view cam type
after-market
factory or none
6
Type of front camera
activation
for 10 seconds after disengaging
the reverse gear and manually by
keypad
only manually by
keypad
7
Video reprtesentation
big size picture
small size picture
8
No function
set to OFF
