Version 10.02.2023
HW:CAM(V100)/(V20+V41) + CAM(V100)/(V21+V41.3)
RL4-MM-NP
P
a
g
e
7
2.
Installation
To install the interface, first switch off the ignition and disconnect the vehicle’s battery.
Please read the owner`s manual of the car, regarding the battery`s disconnection! If
required, enable the car`s Sleep-mode (hibernation mode)
In case the sleep-mode does not succeed, the disconnection of the battery can be done
with a resistor lead.
As with any installation of retrofit equipment, a stand-by test is neccessary after the
installation of the video interface, to ensure that the unit also switches off after reaching
the vehicle
‘s
sleep mode.
Before the final installation, we recommend a test-run of the interface. Due to changes in
the production of the vehicle manufacturer, there’s always the possibility of
incompatibility.
2.1.
Place of connection
The interface has to be connected at the factory head-unit and the factory monitor.
The factory head unit in the Insignia-B is possibly located in the passenger footwell on the
right side under the glove compartment.
