Version 28.04.2022
HW: CAM(V31)/(V10)
RL1-MIB2-E
P
a
g
e
12
Carefully lead the monitor’s brown colored 50pin
ribbon cable into the preassembled ribbon cable merger
of the daughter PCB’s 50pin ribbon cable
“PNL
-
OUT”
.
Make sure that the connector pins are faced to
the
merger’s
platinum.
After a check of its perfect position, close the
ribbon cable merger’s lock, by folding back
the black hinge, to fix the connection again.
To avoid any kind of vibration-caused short circuits
After the
connection, it’s necessary to isolate both
sides of the merger with some kind of smooth issue
tape as shown in the picture beside.
