Navistar Electrical Systems CV
Integration Guide
Page 73 of 84
Revision Date: 9/12/2019
Crimp and Seal Splice Sleeve Installation:
Parts Information:
Part Number
Description
Quantity
3517501C1
12-10 AWG Splice
2
3517502C1
16-14 AWG Splice
7
3517503C1
22-18 AWG Splice
2
2644000R1
Dual Wall Heat Shrink, 50mm
50
NOTE - A new sleeve must be located a minimum of 1.5 inches (40 mm) from a
connector, clip or another sleeve.
1. Cut off the old sleeve or bad section of the wire.
2. Remove insulation being careful not to cut any of the wire strands.
3. Install the proper sleeve on the wire strands, making sure the ends of the wire hit the
stop.
4. Hand crimp to the sleeve. Gently tug on the wire to make sure that they are secure.
NOTE - Always use the recommended crimp tool for each sleeve. A detailed crimp chart
is included in the Repair Kit.
CAUTION - Use appropriate heat gun. Do not use a match or open flame to heat
the sleeve seal.
5. Electrically check the sleeve and wire cable for continuity.
Crimp and Seal Splice Sleeve Installation
1. WIRE STRANDS
2. WIRE STOP
3. CRIMP CONNECTOR
4. EVIDENCE OF GLUE