5
EN
ENGLISH
ASSEMBLY INSTRUCTIONS
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws completely
until all screws for that step have been installed. Hardware combination involving a locking washer and washer should be
installed with the locking washer closest to the head of the screw.
1. ASSEMBLE THE GREASE TRAY SUPPORT
Parts Required:
2 x Grease Tray Support A
(#15)
2 x Grease Tray Support B
(#16)
4 x Screw
(#D)
Installation:
• Mount Grease Tray Support A to Grease Tray Support B using four screws.
2. MOUNTING THE GREASE TRAY TO THE MAIN BARREL
Parts Required:
1 x Main Barrel / Hopper Assembly
(#11)
6 x Screw
(#A)
6 x Washer
(#B)
6 x Locking Washer
(#C)
Installation:
• Place a piece of cardboard on the floor to prevent scratching the unit. Lay the
Main Barrel on it's side, hopper end pointed upward on the cardboard.
• Mount Grease Tray Support to the floor end of the Main Barrel using six
screws, locking washers and washers.
ASSEMBLY PREPARATION
Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister pack after
removing from the protective shipping carton. Discard all packaging materials from inside and outside of the grill before assembly, then
review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt to assemble. Shipping damage
is not covered under warranty. Contact your dealer or Pit Boss
®
Customer Service for parts: Monday through Sunday, 4am - 8pm PST (EN/
FR/ES).
[email protected] | Toll-Free: 1-877-303-3134 | Toll-Free Fax: 1-877-303-3135
IMPORTANT: To ease installation and avoid injury, use two people when assembling this appliance.
Tools required for assembly:
screwdriver and level.
Tools not included.
1
16
15
2
11
15
B
A
C