Radio Removal
Radio Removal Images
1. Pop out the cover under the radio. R
(2) Torx screws behind the cover.
2. Remov
2 |
P a g e
emove
e screws behind hidden cover above
the radio in
the radio.
radio cover hinges.
3. Remove (4) Torx screws securing
place, and then remove and unplug
Wiring Instructions
Note: Wire directly behind DVD changer.
1. Cut the wires going to pin (1) and pin (11) on the factory harness from DVD changer to vehicle radio.
de
(11) vehicle side of
f
6. Connect the Red wire to co12v source. Interface harness Pin (7).
7. Connect the White/Red wire to co12v source via a Toggle switch. Note: Video-In-Motion default is
enabled. Connect this wire to toggle switch to p
isable Video-In-Motion video.
8. Connect the Black wire from the interface harn
) to vehicle ground.
2. Solder the Yellow/Black wire from the interface harness Pin (1) to the factory harness wire Pin (1) vehicle si
of the cut wires.
s wire Pin
3. Solder the Yellow wire from the interface harness Pin (2) to the factory harnes
the cut wires.
4. Solder the Yellow/Black wire from the interface harness Pin (5) to the factory harness Pin (1) DVD changer
side of the cut wires.
5. Solder the Yellow wire from the interface harness Pin (6) to the factory harness Pin (11) DVD changer side o
the cut wires.
ower to d
ess Pin (3
9. Connect the Cluster USB cable to the Cluster module. (Have the “A” connector side of the cable accessible to
the passenger side of the vehicle cabin, but hidden from view. Label USB cable Cluster.
10. Connect the VIM USB cable to the VIM module. (Have the “A” connector side of the cable accessible to the
passenger side of the vehicle cabin, but hidden from view. Label USB cable VIM.
Notes:
1.
he default operation of the W221VIM is to allow video
T
s
in motion. If this is the desired state, then an on/off
witch does not need to be used and the wire from Pin (4) White/Red does not need to be connected. If
toggle switch, su
to turn it Off.
2. If the vehicle is equipped with a factory iPod interface, the wires at pins 1 and 11 on the DVD changer will both
be Brown. When the vehicle has no iPod interface, those wires will be Yellow/White and Yellow, respectively.
3. The CAN wires must be cut at the DVD changer and our modules must be connected in-line with those CAN
wires.
4. All connections must be soldered to ensure reliability.
deactivation of the video-in-motion feature is desired, connect the wire from Pin (4) to +12v source using a
ch that when the switch is closed, it will p12v to the W221VIM
Agreement:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product.
If you do not agree, please discontinue use immediately and return product to place of purchase.
