BHM
10/18/18
NTV-DOC328
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product.
If you do not agree, please discontinue use immediately and return product to place of purchase. This product is intended for off-road use and passenger
entertainment only.
5 |
P a g e
5.
Remove the screen from the dashboard. The following instructions are for the 2015 C-Class, other
vehicles may be similar.
a.
Using a plastic pry tool, pry up the speaker grill
above the monitor on the top dash.
b.
There are (2x) Torx T20 screws that secure
the monitor to the dash (firing downwards).
Remove these and the monitor assembly will
pull straight out (you may need a magnet to
prevent the screws from falling into the
dash).
6.
Disconnect all harnesses from the monitor and set it aside. Similar to step 4, connect the (power) plug
& play harness to the screen, from the blue connector (previously connected to the screen).
7.
Locate the OEM, typically
Dark Blue
,
4-pin round connector (LVDS) that was removed from the radio in
step 1 from the port on the radio typically labeled
‘DISP’
. Connect this factory plug to the W205v2
interface at the port labeled
‘
VIDEO OUT
’
.
NOTE:
If there is no dark blue LVDS video plug present, use the cable that (when removed)
makes the OEM screen disappear (while radio is on).
NOTE:
You may have to shave the keyway of the OEM connector to fit it into the female
side of this connector for some vehicles.
From 8-pin
monitor plug
To Monitor