Installation is made at the front monitor and radio.
Remove the radio surround trims and the radio top trim
on Sport, then pull forward the leather side trims that
cover the bottom screws of the air vents (circled below)
Remove the 4 screws holding the air vents and
remove,
Remove the screen.
Access is now available to the rear of the radio to
connect the supplied loom.
On LR3 you may remove the radio by removing the 4
screws and unit above housing hazard button.
LOCATION & REMOVAL
Installation for VIMCANROV / OPV-1LR CAN:
For Range Rover sport and LR3 The supplied loom is to
be inserted into the radio,
(there is no need to remove the radio on RR sport)
Plug the black plug from the radio into the female side
of the supplied harness, then plug in the male side of
the supplied harness to the radio. Plug in and mount the
interface.
Installation for OPV-1LR MOST
Connect the supplied VIDEO input lead to the GREEN
socket on the rear or the SCREEN and insert your video
lead.
INSTALLATION
INSTALLATION
Fig 1
Fig 2
In the case of the car having a factory
reverse camera, using a standard relay,
you will need to use the car’s 12v+ re-
verse signal to break PIN5 of the OPV-
1LR CAN harness. This means when in
reverse the power to PIN 5 is lost an so
switches off the interface.
Insert the OPTICAL leads into OPV-1LR loom and car loom
AT THE SCREEN to create loop, see diagram below;
To remove the (out) fibre optic cable from the factory connec-
tor you will need to remove the black outer casing and push
out the blue locking insert. You will need to do the same to
insert the cable into the supplied loom. (shown in previous fig)
Other Connections
Connect the RED cable to 12v+ PERM
Connect the BLACK cable to 12v- GROUND
Connect the cable AUDIO sockets on the OPV-1LR to your
audio source.
Plug in and mount the interface.
INTERFACE
CAR CONNECTOR
OUT cable from screen
IN cable from interface
