BHM
10/18/18
NTV-DOC307
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product.
If you do not agree, please discontinue use immediately and return product to place of purchase. This product is intended for off-road use and passenger
entertainment only.
3 |
P a g e
Installation (Porsche)
1.
Remove the factory radio tuner, this requires dropping the glove-box. Disconnect any associated
harnesses and set the radio aside.
2.
Grab the provided
Power/CAN Harness
from the PCM41-CAM kit. Connect the following wires to the
car
radio’s main power plug
:
3.
Remove the
OEM, Gray
LVDS Video Cable
from the radio and connect it to the port
on the PCM41-CAM interface labeled
LVDS-OUT
.
4.
Connect the provided
4-pin LVDS cable
(teal) to the port on the PCM41-CAM
interface at the port labeled
‘
LVDS IN
’
.
Connect the other end of this cable to the
Gray
port on the radio tuner.
Interface wires
Connect to car
Radio Plug
Black (Ground) (-)
Chassis Ground
PIN 15 (Brown)
Red (12v) (+)
AUDI:
ACC 12v (fuse box)
---
Porsche/VW:
Constant 12v
PIN 16 (Red/Yellow)
Green (Rev 12v in)*
Reverse Lamp (+)
---
Installation connections remain the same for all vehicles (except AUDI
–
see
note below), be sure to set dip switches appropriately.
*Note: this Green wire is ONLY required if
CAN connection does not switch display
to reverse image while in reverse
properly, or for an analog camera trigger
(selectable AV1 or reverse camera)
