BHM
11/28/17
NTV-DOC155
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of
its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is intended for off-road
use and passenger entertainment only.
4 |
P a g e
*Note: When the factory front camera is forced on, the active factory guidelines are not
enabled. Only when the vehicle is in 4L will the active guidelines be available.
13.
Optional:
If you send 12v (through a toggle) to
Input 2 (Blue)
, it will force the rear camera.
14.
Optional:
If you send 12v (through a toggle) to
Input 3 (Orange)
, it will force VIM operation.
10. Locate the
gray/violet
wire and cut it
in half.
9. On the
underside of the
hood, traveling
down the
driver’s side, is
the camera
harness. Cut the
harness open at
the bottom of
the hood.
11. Connect the extended wire labeled
“Camera” (pin 6), to the camera side of the cut
gray/violet wire. Connect the extended wire
labeled “BCM” (pin 16) to the vehicle side of
the cut gray/violet wire. Insulate and tape the
connections when finished.
12. Plug the male end of the Plug & Play harness into the factory LCD and test for proper operation (refer
to page 5 & 6 for operation instructions).