BHM
11/28/17
NTV-DOC155
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of
its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is intended for off-road
use and passenger entertainment only.
3 |
P a g e
VIM & F-CAM Installation
1.
Remove the factory My Ford Touch radio. This requires removing panels and various 7 & 8mm
screws. The trim panels securing the center radio bezel do not need to be fully removed, just
moved out of the way.
a.
There are (2x) 7mm screws hidden beneath the airbag module and therefore the airbag
module must be popped out (no need to disconnect entirely).
Apply tape for protection
to the dashboard just beneath the airbag before you do this!
b.
Remove the passenger airbag assembly by removing the (3x) 8mm screws firing up from
underneath the airbag. Access these screws by dropping the glove box down to the floor
(again, no need to remove it entirely).
c.
Remove (or pop free at the right bottom corner) the cluster surround, and pull aside the
trim pieces that surround the radio.
2.
Remove the (4x) 7mm screws holding the screen in place.
3.
Disconnect all wiring and set the screen aside.
4.
Gather the Plug & Play harness from the F-CAM kit.
5.
Plug the main LCD harness (male) from the car into the
female side of the F-CAM Plug & Play harness.
6.
Gather the
‘A’
and
‘B’
modules, and connect them to their
prospective, labeled connecters.
Steps 7-11 are intended for F150 Raptor
’s only, those with an
OEM front
camera. If are adding an aftermarket front camera to a standard F150, you must
purchase NTV-KIT437 as well and should refer to that instruction set (pg 5&6) at
this time before returning and completing the install here (begin again with step
12 upon returning).
7.
Under the driver’s dash, make a small incision in the rubber harness grommet going through
the firewall on the driver’s side.
8.
Connect a 10’ pair of
wires to the F-CAM
module A
: connect one of the wires to pin 6 and the
other to pin 16. Route the free end of the wire pair through the firewall (at your incision), into
the engine bay of the vehicle. Use silicon or 3M strip caulk to seal the incision.