BHM
12/18/13
NTV-DOC152
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
4 |
P a g e
7.
Connect the AV Input cable to the port on the MAS-GT interface labeled
‘AV IN/OUT’
. If
you’re only connecting a reverse camera (and no other
inputs), the signal input from the camera must connect
to the RCA labeled
‘REAR-C’
. Refer to the dip-
switch settings chart to skip/enable AV sources
upon toggle switch presses (Optional. Page 2).
a.
If you’re installing a Nav-TV
CAM 6
or
Handle Cam
along with this interface,
the power connector plugs directly
into the MAS-GT interface port
labeled
‘R-CAM’
for power.
b.
Note:
The MAS-GT interface will not activate rear-cam with the CAN connection.
You must select the activation as
‘LAMP’
under the menu settings:
’UTIL --> Rear
Select’
section.
Refer to step (8a.) to adjust this.
8.
Connect the remote eye to the port labeled
‘IR’
and mount it in
clear view of the driver (often it can be stuck inside a vent). This
connection would be necessary if you want to be able to adjust
anything from the MAS-GT interface’s menu.
a.
While in any AV mode other than factory
(on the display
screen), press the
MENU
button
for
MENU 1
,
or
hold the
left arrow
to enter
MENU 2.
b.
To switch between AV modes, press the
‘OK’
button.
9.
Optional:
Connect the provided momentary toggle switch to the
port on the MAS-GT interface labeled
‘MODE S/W’
(in the power
harness). Pressing this switch with the ignition on will cycle
through any enabled screen modes.
10.
Connect the MAS-GT Power harness to the interface at the
port labeled
‘POWER’
. Start the car and test for proper functionality before
replacing dash pieces.
11.
Note:
All other included harnesses not mentioned in this manual are not needed for most
installations.
If you would like to know more about the full capability of this interface,
contact NAV-TV tech support at 561-955-9770. Additional features not mentioned in this
manual are not supported by NAV-TV at this time.