BHM
12/18/13
NTV-DOC152
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
3 |
P a g e
Installation
1.
Disassemble the dashboard and remove the radio. This usually requires pulling panels
and removing screws. Disconnect any harnesses from the radio and screen and
set them aside.
2.
From the provided MAS-GT
Power
harness, connect the following wires to the
car:
3.
Connect the provided
LVDS cable
from the main MAS-GT
interface (port
‘LVDS OUT’
) to the MAS-GT Sub
interface (port
‘LVDS IN’
). Connect the silver ground
terminal on each end of this cable to the screw closest to
each port (on each interface).
4.
From the car’s media screen, find the factory harness with a
keyed, 10-pin plug that will fit in the port pictured below (step 5).
5.
Plug this connector into the MAS-GT
Sub
interface port labeled
‘OEM LVDS INPUT’
.
6.
Use the provided
LCD Cable
and connect the white
connector to the MAS-GT Sub interface port labeled
‘LVDS OUT’
.
The other end of the cable connects to the
factory screen.
Wire color (MAS-GT Harness)
Connect to Car
Black (GND)
Chassis Ground (-)
Red (ACC)
12v Accessory source (+)
Gray (rear)
Reverse light trigger