BHM
02/18/19
NTV-DOC166
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
3 |
P a g e
Installation
1.
Locate the factory navigation drive and gain access to the connectors. The drive usually
can be found in the trunk. Disconnect any connected harnesses to the NAV drive
temporarily.
2.
Gather the provided
‘Power/CAN Harness’
from the GVIF-JAG kit. Connect the
following wires to the car:
Note: CAN connection is not supported at this time. You must connect the GRAY wire
to a reverse lamp for reverse activation!
3.
Disconnect the factory GVIF cable from the NAV drive, this is a
square, blue connector.
4.
Connect the
male side (labeled ‘L
X
IN’) of the
provided
GVIF video
cable
to the NAV drive.
5.
Connect the free end (removed in step 3) of the factory GVIF
video cable to the female side of the provided
GVIF video cable
(labeled ‘LXOUT’).
6.
Connect the white end of the GVIF video cable to the interface at the port labeled
‘
GVIF
IN/OUT’
.
7.
Connect the AV Input cable to the port on the GVIF-JAG interface labeled
‘AV IN/OUT’
.
If you’re only connecting a reverse camera (and no other
inputs), the signal input from the camera must connect
to the RCA labeled
‘REAR
-
C’
. Refer to the dip-
switch settings chart to skip/enable AV sources
upon toggle switch presses (optional. Page 2).
8.
Adjust dip switches on the GVIF-JAG interface properly, refer to the chart on page 2 for
qualifications.
9.
Connect the white plug from the
‘Power/CAN Harness’
to the port on the GVIF-JAG
interface labeled
‘Power/CAN’
.
Interface wires
Connect to car
Black (GND)
Chassis Ground
Red (ACC)
Accessory
Gray (Rear)
Reverse lamp 12v (if adding rear camera)
