BHM
10/17/18
NTV-DOC275
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
4 |
P a g e
6.
Connect the provided 12-pin plug & play portion from the main power harness to the
main factory MMI connector as shown below. Pay attention to the orientation, as this is
vital to proper operation:
7.
Connect ground and power for your camera, you may use the provided
purple
wire
(labeled ‘REAR12VOUT’) for power for convenience.
NOTE:
This power source will only
supply 12v when the vehicle is in reverse (if forced rear camera is desired at any time,
you’
ll need to use an ACC source for power instead).
Remove gray OEM 12-pin
Connect the female 12-pin side of the plug
& play portion to the OEM main MMI
connector as shown.
Note the paint dot
must face towards the thick power wires.
If the connector does not secure properly,
zip tie the harness in place to surrounding
wires
leaving slack so that the connector
stays in place.
Use a spot of glue on the
back side if you’re still concerned with
this.
Note: sometimes it is easier to connect the
main plug back to the MMI module first
and then connect this 12-pin in.
Connect OEM 12-pin to provided 12-pin
(black, PIN-side).
NOTE: printed arrow
location on provided 12-pin plug vs OEM plug.
