© Nauto 2019. All RightsReserved.
Installation | OBD Connection
OBD Port Connection (with Y-Cable)
1. Locate the OBD port within the vehicle, removing vehicle panels as necessary.
2. Gently remove the factory OBD plug from the mount.
3. Replace the vehicle’s OBD port with the female end of the Nauto Y-cable.
4. If there was an existing device in the vehicle’s OBD port, reconnect it utilizing the Nauto Y-cable.
5. Plug the male end of the Nauto Y-cable into the vehicle’s OBD port. Ensure ignition is off when connecting.
6. Zip tie all connections to help ensure plugs will not disconnect.
6
OBD PortConnection (without Y-Cable)
1. Locate the OBD port within the vehicle.
2. Insert male end of the Nauto OBD power cable into the vehicle’s OBD port
© Nauto 2020. All RightsReserved.
Installation | Power Cable Connection
Power end of powercable
Power Cable Connection
1. Locate the power end of the power cable, or the end with the small black block (see image
for reference).
2. Leave 8-10” of the cable exposed at the rearview mirror and route the cable safely and
securely to the power supply unit.
3. One way to do so that may be appropriate is as follows:
a. Start tucking the cable under the windshield headliner starting just above the
rearview mirror.
b. The cable should be buried under the headliner so that it will not slide out or drop
from the headliner.
c. Route the cable to the left (driver’s side of the vehicle) and remove the A-pillar
panel to route the cable around, behind, and away from all airbag components and
related vehicle accessories.
d. Pull the door gasket away from the body of the vehicle and run the power cable
into the channel near the pinch weld, but without crossing over the pinch weld,
towards the power supply unit.
4. Bundle and secure all excess wiring so it will not interfere with vehicle and driver controls.
5. Mount the bundled cable in a secure location under the dash of the vehicle with zip ties.
