Nautiques Crossover 90490, Owner'S Manual

Page: 86 / 198

4-18
Section 4
There are three small lights in the dash display that indicate the
status of Nautique Cruise. The top light is labeled MPH, the middle
one labeled RPM and the bottom one labeled SET. When Nautique
Cruise is on, either the MPH or RPM light will be illuminated and
the SET light will either be off, flashing slowly or on continuously.
When the SET light is off, Nautique Cruise will not control speed
and the throttle control will function normally at all speeds. If the
SET light is flashing, Nautique Cruise is armed but the boat speed
is below the set point. The throttle control will function normally as
long as the boat speed is below the set point. When the speed nears
the set point, Nautique Cruise will take over controlling the speed.
When Nautique Cruise takes over, the SET light illuminates
continuously.
NOTICE
After Nautique Cruise takes control, it is best to push the throttle
control handle down a good portion of the way toward full throttle
in order for Nautique Cruise to function correctly. Nautique
Cruise can be turned off by pulling the throttle back toward
NEUTRAL, by pushing the Cancel button or by turning Nautique
Cruise off.
When the ignition is turned off and back on, Nautique Cruise will
“remember” the last set point and return to it. The indicator lights
will provide the operator with an indication of the Nautique Cruise
status.
There are two ways to operate the buttons on the steering wheel
hub. One is to “push and release” (push and after a short delay of
more than 1/2 second but less than two seconds, release the
button). The other is to “push and hold” (push and after a longer
delay of at least two seconds, release the button).
216V Sec 4_2009.qxd:Naut Air Sec 4.qxd 1/21/09 9:21 AM Page 18