Nautilus StairMaster ClubTrack 2100 Series, Service Manual

Page: 32 / 92

28
ClubTrack
®
2100 Series Treadmill Service Manual
1 Place the magnetic key in its location on the Ergo bar.
2 On the keypad, press CLEAR , 3 , 8 , and ENTER .
3 Press the SPEED � or SPEED � to select “ON.”
4 Press ENTER .
5 Cycle the power.
The magnetic key feature for the treadmill is now active. If you remove the key, the treadmill belt will stop, and the
controller will not respond to any key presses. The console will display a message “REPLACE MAGNET” when you
remove the magnetic key from its designated area. You must replace the key or deactivate the control to start the
treadmill belt.
Deactivation
1 With the magnet key in place and the display at the opening message “SELECT WORKOUT,” press CLEAR , 3 ,
and 8 . The console will display “ENABLE MAGKEY.”
2 Press ENTER , and the display will either read “ON” or “OFF.”
3 Press the SPEED � or SPEED � key to toggle between “ON” and “OFF.”
4 Select “OFF,” and press ENTER . The display will show “UPDATING” for a few seconds, then display the off
setting.
5 Turn off power to the treadmill at the circuit breaker switch. The circuit breaker switch is located on the bottom
front panel of the treadmill.
6 Remove the magnet key.
7 Turn power to the treadmill back on at the circuit breaker switch. The display will show the “SELECT
WORKOUT” screen. The limited-access control remains inactive, granting unrestricted access until you turn the
magnetic key option back on or place the magnet back in its designated area.
Magnetic Key as an Emergency Stop
The magnetic key has a string with a clip that attaches to your wrist or belt during exercise. If you move too far from
the front handrail, the cord will pull the key off and stop the treadmill walk belt.
Magnetic Key Limit Access Control