17
NS-4000
A.
Place the ring of the Tethered Weight Selector Pin (145)
around the center hump of the Top Weight Assembly.
B.
Thread one end of the Pec Fly Cable (93) into the Top
Weight Assembly on the weight stack closest to the Pec
Fly Station. Do not tighten locking nut.
C.
Feed the Cable (93) over the 4 1/2" Pulley (90) located
in the Bracket above the weight stack.
D.
Loop the Cable (93) around a 4 1/2" Pulley (90) and
attach it to the two Pulley Plates (62) using the
hardware shown.
E.
Draw the Cable (93) over the Main Top Frame. Proceed
by feeding the Cable (89) around the 4 1/2" Pulley (90)
located on the Pec Fly Main Frame.
F.
Connect the end of the Cable (93) to the Pec Fly Range
of Motion by attaching it to the small "C" channel bracket
as shown. Tighten all hardware used in this step
securely.
step
11
Step #11 Materials:
#
Component
Qty
62
Pulley Plate
1
90
4 1/2" Pulley
1
93
Pec Fly Cable
2
117
Hex Bolt - 3/8" x 2"L
1
130
3/8" Flat Washer
3
135
3/8" Lock Nut
1
145
Tethered Weight Selector Pin
1
Summary of Contents for NS-4000
Page 1: ...Assembly Instructions NS 4000 Rev E...
Page 2: ...NS 4000 3...
Page 22: ...23 NS 4000 step 17...
Page 25: ...Nautilus Fitness Products 800 864 1270 www Nautilus com...
