Nautilus Mobia, Owner'S Manual, Page: 12 / 14

Moving Moving
Moving YYYour
our
our Machine
Machine
Machine
The Mobia
™
fitness machine weighs approximately 200 lbs (90.7 kg) when fully assembled and requires caution when being moved. Use the Transport Handle found under
the front of the machine to move it. To get access to the Transport Handle, turn the Levelers until you have sufficient clearance between the machine and floor.
Your machine can be rolled on the transport wheels to a new location. Lower your
machine slowly into its new location without injury to your head or fingers.
Do not use the uprights, arms, or the Console to lift or move the machine.
Injury to you or damage to the machine can occur.
The machine can be moved by one or more persons. Make sure that your own
physical strength is capable of moving the machine.
Place the machine on a clean, hard, level surface, free from unwanted material
or other objects that may hamper your ability to move freely. A rubber mat
should be used below the machine to prevent the release of static electricity
and protect your flooring.
For safe storage of the machine and to prevent unsupervised operation of the
machine always remove the Safety Key and disconnect the power cord from
the wall outlet or machine AC input.
TTTroubleshooting roubleshooting
roubleshooting
Condition/Problem Condition/Problem Condition/Problem Things Things Things to to to Check Check Check Solution Solution Solution
Unit will not power up/turn on/start Outlet Make sure outlet is functioning correctly. Verify this
by plugging another object (ex: lamp) into the outlet.
If outlet is connected to a light switch, check to make
sure it is on. If outlet is not functioning find a working
outlet.
Power cord not plugged in
Make sure the power cord is firmly secured to A/C
inlet on the unit and firmly inserted into a non-GFI wall
socket.
Power switch turned off Make sure the power switch at the rear of the unit
is in the “ON” position. Switch will light up red to
indicate power is present.
Safety key not plugged in Plug Safety Key into Console (See Emergency Stop
Procedure within the Important Safety Precautions
section).
Speed displayed is not accurate Display set to wrong unit of measure. (English/Metric) Change display units.
Heart rate not displayed while using chest strap Transmitter not making good contact with skin Moisten skin contact area on the chest strap.
Electromagnetic interference Turn off any television, AM radio, microwave, or
computer within 6 feet (2 meters) of the fitness
machine.
Chest strap transmitter Test chest strap with another HR monitoring device
such as HR watch or a machine at a gym. If transmitter
has good skin contact and still is not found to be
emitting HR signal, replace chest strap transmitter.
12 12
12