Nautilus Hydro-Force MX3-200H, Operating Manual, Page: 28 / 55

28
CLEAN THE HYDRO-FILTER II: (If so equipped)
When used with the MX3-200H, build-up of debris in the filter screen of the optional Hydro-Filter II will
reduce the vacuum air flow and may cause a significant decrease in water recovery. A torn filter screen will
allow debris past the filter and into the recovery tank. This debris can clog the Waste Pump and the Vacuum
Shutoff Assembly.
The Hydro-Filter II must be examined and cleaned regularly to keep the MX3-
200H functioning properly:
• Grasp and turn the lid counterclockwise to open the Hydro-Filter II lid.
• Remove the filter screen. Examine the screen and clean or replace as needed.
•
Rinse the body of the Hydro-Filter II with clean water.
• Examine the o-ring lid seal and replace as needed.
• Re-install the new or cleaned screen.
• Screw the lid back onto the body and turn clockwise to tighten.
RINSE OUT RECOVERY TANK:
Build-up of fine silt and debris can damage the Waste Pump and Drain Valve. Clean out the tank on a regular
basis to extend the life of these components as well as keep the tank and machine smelling better.
•
Remove the recovery tank lid and open the drain valve.
•
Place a bucket under the drain valve.
• Use a hose to rinse the dirt and debris out of the recovery tank.
• Close the drain valve and spray the tank with a deodorizer or disinfectant.
• Proceed to Waste Pump Cleaning and replace the recovery tank lid.
• Dispose of the dirty water and debris.