Nautilus HYDRO-FORCE MX1200M, Operating Manual

Page: 21 / 93

21
9. Pressure Adjustment:
To make it easier to check and adjust the pressure, the pressure gauge and the pressure regulator are mounted
on the control panel on the front of the machine. When the high-pressure solution pump is on and primed,
pressure will show on the gauge.
•
To decrease the pressure, turn the brass knob on the pressure regulator to the left (counter-clockwise.)
•
To increase the pressure, turn the brass knob on the pressure regulator to the right (clockwise.)
• To adjust pressure to your tool and surface requirements:
o
Check the pressure on the gauge.
o
Re-adjust as needed to set the machine at the desired pressure.
o
Choose the pressure setting that best meets your type of cleaning.
Pressure gauge & Regulator/Unloader
To increase the solution pressure, turn the
regulator knob clockwise.
To decrease the solution pressure, turn the
regulator knob counter-clockwise.
The maximum pressure setting is specified on
machine; however, the highest pressure attained is
dependent on the amount of water flow at the tool:
•
Smaller jets and lower flow will allow for
higher pressure at the tool.
•
Larger jets and higher flow will lower the
maximum pressure attained at the tool.
The desired setting will depend on the type of
cleaning and tool used. For example:
• Carpet Cleaning with 2-jet 1683-0123 wand:
400psi
•
Upholstery Cleaning with A96894 tool: 200psi
If adjusting or maintaining pressure becomes a
problem, refer to the trouble shooting guide or
contact your distributor for advice or assistance.