28. Release the main harness (20-pin
connector), the ergo harness (4-pin
connector), and the TV coaxial cable from
the console mounting plate. Pull the excess
harness and cable out of the access hole.
29. Place the rear of the touchsreen
console near the mounting plate so that the
harnesses and cable can be connected.
30. Connect the main harness to the
console at JP3 as shown in Figure 5.
31. Connect the ergo harness to the
console at J12 as shown in Figure 5.
32. Connect the TV coaxial cable to the
console using the supplied female-to-
female connector. Note that 7” consoles are
not TV ready and will not have a coaxial
cable connection.
33. Route the iPod cable through the access
slot in the rear of the console housing.
34. Remove the (6) 1/4-20 pan head screws
from the rear of the console. Position the
console against the mounting plate so that the
holes are aligned. Secure the console to the
mounting plate using (4) 1/4-20 pan head
screws as shown in Figure 6. Use the #2
phillips head screwdriver to tighten.
35. Position the iPod holder against the
console so that the holes are aligned.
Secure the iPod holder to the console using
(2) 1/4-20 pan head screws. Use the #2
phillips head screwdriver to tighten.
Figure 5
NOTE: Do not connect the 15V power supply to the machine until
the console has been installed! If the console must be removed
and disconnected for any reason, ensure that the power supply is
disconnected first!
Figure 6
Main Harness To JP3
Ergo Harness To J12
assembly questions? call 800-235-2233 for help.
18
