Service Manual Chapter8. CDU (Cash Dispenser Unit)
©
Nautilus Hyosung, Inc.
All Rights Reserved.
8-27
Adjustment Standard
Gate Adjustment
▶
Gate Adjustment
①
Loosen the solenoid M4 screw (2 places) as much as possible.
②
Adjust the solenoid position so that the gate is at least 1.5mm [0.56inch] away from
the shaft when you pull the gate as shown in the below right figure.
③
Adjust the solenoid position so that the gate is 1.5mm [0.56inch] away from the
shaft, when pulling the gate as shown in the right below figure.
GATE를 당겼을 때
GATE를 놓았을 때
1
.5
m
m
OBLONG
EMBOSSING
M3 STOP SCREW
GATE
GATE
ADJUSTMENT JIG
SOLENOID BRACKET
SOLENOID ADJUSTMENT
BRACKET
GATE
1
.5
m
m
GATE
ADJUSTMENT JIG
OBLONG
SOLENOID SENSOR
BRACKET
SHAFT
SHAFT
④
Fix the solenoid M4 screws (2 places).
When the gate is pulled
When the gate is released
Φ
2 E-RING
44950404