Nautel NX300, Installation Manual

Page: 21 / 70

NX300 Installation Manual Completing cabinet assembly
Issue 3.0 2012-11-01 Page 3-7
30. Cabinet assembly is complete. Leave the back doors open to allow installation of ac power
wiring (see Section 6, “Connecting ac power” on page 6-1 ) and assembly of the output
cabinet’s station reference ground (see Section 5, “Connecting the station reference ground”
on page 5-1 ). Leave the front doors and filter doors open to allow spark gap adjustment (see
Section 7, “Adjusting the spark gap” on page 7-1 ), audio wiring (see Section 8, “Installing
audio inputs” on page 8-1 ) and control/monitor wiring (see Section 9, “Installing control/
monitor wiring” on page 9-1 ).
31. After completing all installation requirements described in Step 30 :
• Close the filter door in each cabinet and secure using M5 screws retained in Step 6 . Make
sure to use all screws.
• Close all front and rear doors opened in Step 3 . Doors are unlatched open by pushing up
on the door stop arm while starting to close the door.
• Reinstall the side panels on the control cabinet and output cabinet by aligning the hooks
and sliding downward. Secure each using the three M5 screws retained in
Step 1 ..