Nautel GV3.5, Operation & Maintenance Manual, Page: 214 / 251

GV5/GV3.5 OPERATIONS & MAINTENANCE MANUAL OPERATING THE TRANSMITTER
VERSION 0.2 2014-07-23 PAGE 3.2.197
Configuring the Transmitter for the Orban Audio Processor
Configure the GV5/GV3.5 to recognize the presence of the Orban card using the controller UI (see
Orban Enabling - using the Controller UI ) or the AUI (see Orban Hardware Configuration - using the AUI -
see page 3.2.198 ) as follows:
NOTE
: Configuring the Orban audio processor locally will cause the AUI to display an Orban Inside
setting. The same occurs on the controller UI when configuring via the AUI.
Orban Hardware Configuration - using the Controller UI
1. With the transmitter turned on and in local mode of operation, navigate to the controller UI's
Main Menu -> System Settings -> HW Config
menu. Scroll down through this menu and select
Audio Processor
(see Figure 3.2.168 ).
2. In the
Audio Processor
screen( see Figure 3.2.168 ), use the up and down buttons to toggle
between
None
and
Orban Inside
(default factory setting is
None
). Select
Orban Inside
to enable
the Orban audio processor for use (selecting
None
disables it). Press the accept (checkmark)
button to save the change. Press cancel (
X
) to discard changes and return to the previous menu.
3. Reboot the transmitter by switching the ac power off and then on. This will ensure the transmitter
properly detects the Orban Inside card upon recovery.
Figure 3.2.168: Configuring the Transmitter - Controller UI HW Config and Audio Processor screens