the device is being used. The last digit refers to tenths of hours, with 0.1 = 6
minutes. To reset the timer, please refer to the service manual.
Phototherapy Roll Stand
The roll stand is designed to hold the neoBLUE light with a base designed to
accommodate the weight distribution of the light enclosure at any height or
angle.
Warning! If an alternative stand is used, care must be taken to
validate the load capacity. See Regulatory/Safety Standards (Section 8).
Caution: Use care when repositioning the roll stand around other
equipment to prevent accidental change or damage to surrounding
equipment.
The roll stand operates on a gas shock to maintain a safe pole height during
adjustments.
The roll stand incorporates features to adjust the height, tilt and proximity of
the light source as described in Section 3.1.
Power Requirement and Accessories
The light is mains-power operated. The power cord plugs into a receptacle at
the power inlet at the back of the light enclosure. There are no single-use
components for the light. A power cord strain relief bracket is provided to hold
the power cord in place.
Lighted Green On/Stand-by Switch
The lighted green switch (between the target light switch and the intensity
switch) is used to turn the device on or put it in stand-by mode. The switch
should only be illuminated when in the on position. When in the stand-by
position, line voltages are still present inside the device if the device is
plugged in, but no DC voltage is being switched to the LED panel, fans or
timer.
Accessory Pack
An accessory pack is included with each light enclosure. The accessory pack
contains the following items: a CD, a power cord, a power cord strain relief
bracket to hold the power cord in place, vent filters and extra thumb screws
and mounting posts for attaching the light enclosure to the roll stand.
neoBLUE
®
LED Phototherapy System User Manual
3
PN 001364 Rev. I
Summary of Contents for neoBLUE
Page 1: ...User Manual...
