11.5.2 OTHER Dynamic
The second
OTHER
parameter,
Dynamic
, is only available in
Arp
mode. On the keyboard it is
mapped to Knob 7 of the Control section in Arp Edit mode. It reads the velocity of the input—
e.g., a key you pressed on the KOMPLETE KONTROL keyboard or an incoming MIDI note from
the host—and scales it by the factor you set with the
Dynamic
parameter. The scaling is ap-
plied per note. The velocity of each played note is taken and multiplied by the value set with
the
Dynamic
parameter.
Dynamic
is a drag control that lets you set a value between
1.0%
and
200.0%
.
To display the set value of the
DYNAMIC
parameter, tap Knob 7.
11.5.3 OTHER Gate
The third
OTHER
Parameter,
Gate
, is available in both
Arp
and
Note Repeat
mode. On the key-
board, it is mapped to Knob 8 of the Control section in Arp Edit mode. It lets you decide the
length of the notes in your sequence. Setting a value between
1%
and
99%
makes the dura-
tion of the notes shorter than they otherwise would be. Setting a value between
101%
and
200%
instead elongates the duration of the notes by the selected value.
Gate
is a drag control that lets you set a value between 1.0% and 200.0%.
To display the set value of the
GATE
parameter, tap Knob 8.
11.6 ADVANCED Parameters
The
ADVANCED
parameters
Retrigger
,
Repeat
,
Offset
, and
Inversion
allow you to explore alter-
native versions of the same arpeggiator sequence.
Smart Play – Playing and Editing Arpeggiator Sequences
OTHER Parameters
KOMPLETE KONTROL A-Series - Manual - 138
Summary of Contents for A Series
Page 1: ...MANUAL ...
