CAUTION : When soldering lead wires on switch,
location and orientation of lead wires
must be as shown in Figure 1.
(1) Solder yellow and white lead wires into the heater as
shown in Figure 2.
(2) Assemble the heater into slots of the motor block as
shown in Figure 3.
(3) Insert the red, black and blue lead wires between the
guide post of the air flow assembly as shown in Figure 4.
(4) Insert the motor block into slot of back housing as
shown in Figure 4.
Figure 1
Figure 2
Figure 3
Figure 4
3 ASSEMBLY INSTRUCTIONS
(5) Install the switch at the position as shown in Figure 5.
(6) Position all lead wires as shown in Figure 5.
(7) Set the power cord, bushing and fasten 2 screws at the power cord retainer as shown in Figure 5.
Figure 5
4
EH5235-A3
Summary of Contents for EH5235-A3
Page 3: ...3 EH5235 A3...