NI Digital System Development Board User Manual
|
© National Instruments
|
17
The signals from the NI ELVIS edge connector are routed to the Power breadboard header, the
NI ELVIS Analog breadboard header, and the programmable logic of the Zynq. The connections
are described in Tables 4 and 5 below. NI ELVIS pins not listed in the tables below are not
connected to any device on the DSDB. Note that +5 V from this connector is also used to power
the entire board. The GND pins of the NI ELVIS connector, the ground plane of the DSDB, and
the pins labeled GND on the breadboard headers are all connected. For further information on
the functionality of the pins on the NI ELVIS connector, please refer to the NI ELVIS
documentation.
Table 4.
NI ELVIS breadboard connections
NI ELVIS Pin
Zynq Pin
DIO0
Y20
DIO1
AA16
DIO2
Y19
DIO3
AB16
DIO4
AA18
DIO5
AB15
DIO6
Y18
DIO7
AA14
DIO8
T19
DIO9
AA19
DIO10
U20
DIO11
AB19
DIO12
U10
DIO13
AA17
DIO14
W20
DIO15
AB17
PFI8
N19
PFI9
AB20
PFI12
R21