![background image](http://html1.mh-extra.com/html/national-instruments/tpc2106t/tpc2106t_user-manual_3461125012.webp)
Chapter 2
System Setup
©
National Instruments Corporation
2-3
2.
Connect the power connector to 24 VDC power lines. Be sure
to connect the positive, negative, and ground lines as shown in
Figure 2-1. The power lines can be from either a power adapter or
in-house power source.
Figure 2-1.
Power Connector
3.
Connect the power connector to the power receptor on the
TPC-2106/2106T. The power receptor pin assignment is shown
in Figure 2-2.
Figure 2-2.
Power Receptor and Pin Assignment
4.
Power on the system.
Touchscreen Calibration
The TPC-2106/2106T touchscreen should be correctly calibrated and ready
to use when you power on the system. However, if the calibration is not
correct or you want to choose custom calibration options, refer to the
section of Chapter 3,
.
+
–
GND
GND
–
+