BNC/TC-2095 Rack-Mount Adapter Installation Guide
14
ni.com
Figure 5.
Resistor Connections
Table 5 shows which resistors are associated with each group of channels.
SCXI-1102/B/C Module
You can replace the 10
Ω
ground-referencing resistor networks
(factory-default configuration) in the BNC/TC-2095 with the 10 M
Ω
resistor networks supplied in the kit. The 10 M
Ω
resistor networks allow
the signal to be ground-referenced or floating. Channels with open
thermocouples saturate at all sample rates.
Use long-nose pliers to remove or replace the resistor networks in the
sockets. Be careful not to damage the network package. Make sure pin 1
of each network is in the correct socket. Refer to Figures 6 and 7 as needed.
Table 5.
Channel Input Signals and Resistor Network
Channel
Pull-Up Resistor
Network
Ground-Referencing
Resistor Network
<0...7>
RP8
RP4
<8...15>
RP7
RP3
<16...23>
RP6
RP2
<24...31>
RP5
RP1
CH+
CH–
CH+
CH–
SCXI Module or VXI-SC Submodule
R
pull-up
(RP5, RP6, RP7, RP8)
R
ground referencing
(RP1, RP2, RP3, RP4)
(in sockets)
Screw Terminals
5 V
Pull-Up Switch
Ground Referencing
Switch
