©
National Instruments Corporation
7
TBX-1329 Installation Guide
Connecting the Signals
Note
Refer to
before removing equipment covers or connecting or
disconnecting any signal wires.
When connecting your signals to the TBX-1329, follow the labeling on the
TBX-1329 for the appropriate module, as indicated in Figure 1. When
using the TBX-1329 with the SCXI-1125 or SCXI-1126, follow the
SCXI-1120/1120D labeling.
Figure 1.
TBX-1329 Parts Locator Diagram
To connect the signal to the terminal block, perform the following steps
while referring to Figure 2:
1.
Remove the TBX-1329 terminal block cover by unscrewing the four
captive cover screws in the cover corners. These screws stay attached
to the cover without falling out.
1
Current Loop Receiver Resistor
2
Safety Ground Solder Lugs
3
Product Name
4
Assembly Number
5
Serial Number
6
SR7/SC7
7
SR6/SC6
8
SR5/SC5
9
SR4/SC4
10 SR3/SC3
11 SR2/SC2
12 SR1/SC1
13 SR0/SC0
14 SCXI Module-Type Rows
12
11
10
9
8
6
13
1
2
14
2
1
3
4
5
300V MAX CHANNEL TO CHANNEL
300V MAX CHANNEL TO EARTH
7