©
National Instruments Corporation
3
SCXI-1362 Adapter Kit Installation Guide
Do
not
substitute parts or modify equipment. Because of the danger of introducing
additional hazards, do
not
install unauthorized parts or modify the device. Return the
device to National Instruments for service and repair to ensure that its safety features
are not compromised.
You
must
insulate all of the signal connections to the highest voltage with which the
SCXI-1362 can come in contact.
Connections, including power signals to ground and vice versa, that exceed any of the
maximum signal ratings on the SCXI device can create a shock or fire hazard, or can
damage any or all of the boards connected to the SCXI chassis, the host computer, and the
SCXI device. National Instruments is
not
liable for any damages or injuries resulting from
incorrect signal connections.
Clean the module and accessories by brushing off light dust with a soft non-metallic brush.
Remove other contaminants with a stiff non-metallic brush. The unit
must
be completely
dry and free from contaminants before returning it to service.
The adapter
must
be used with a UL-listed SCXI chassis.
Installing the SCXI-1362 Adapter Kit
Refer to Figure 1 when installing the SCXI-1362 adapter kit. To install the
SCXI-1362 kit, complete the following:
1.
Power off the computer and SCXI chassis.
2.
Install the SCXI modules in the SCXI chassis following the
instructions in the module user manuals. When installed, the back
of the SCXI module is not flush with the back of the SCXI chassis.
3.
Install the SCXI-1362 adapter through the chassis into the rear of the
SCXI module. When installed, the SCXI-1362 adapter is flush with the
back of the SCXI chassis. Refer to Figure 1.
4.
Using the two screws included in the kit, secure the SCXI-1362
adapter into the threaded strips in the rear of the SCXI chassis.
5.
Connect one end of the SH9MD-AUX cable to the AUX IN connector
of the SCXI-1362 adapter.
6.
Connect the other end of the cable to the AUX I/O connector of the
switch controller.