© National Instruments Corporation
3
SCXI-1342 Cable Assembly Installation Guide
5. Secure the SCXI-1342 adapter board by screwing the two screws through the rear panel of
the adapter board and into the threaded strips in the rear of the SCXI chassis.
6. Install your data acquisition board in a slot in your computer, following the instructions in
your data acquisition board user manual.
7. Connect one end of the NB1 cable to the rear connector of the adapter board.
8. Connect the loose end of the NB1 cable to the I/O connector on the PC-LPM-16 as shown in
the detail in Figure 3.
The finished installation should look like Figure 3.
SCXI
Chassis
SCXI-1342
Cable Assembly
Computer
NB1 Ribbon Cable
PC-LPM-16 Board
Figure 3. Installed Cable
SCXI-1342 Pin Translations
The following table lists the way that the SCXI-1342 translates pins from the PC-LPM-16 to the
SCXI module.
