SCXI-1335 Terminal Block Installation Guide
6
ni.com
1.
Remove the top cover screw.
2.
Unsnap and remove the top cover.
3.
Loosen the strain-relief screws.
4.
Run the signal wires through the strain-relief opening. You can add
insulation or padding if necessary.
5.
Prepare your signal wire by stripping the insulation no more
than 7 mm.
6.
Connect the wires to the screw terminals by inserting the stripped end
of the wire fully into the terminal. No bare wire should extend past the
screw terminal. Exposed wire increases the risk of a short-circuit
causing a failure.
When connecting your signals to the SCXI-1335, follow the labeling
on the SCXI-1335 for the appropriate module, as indicated in
Figures 2 and 3.
