National Instruments SCXI-1313, Installation Manual, Page: 5 / 14

© National Instruments Corporation 5 SCXI-1313 Installation Guide
Connecting Signals
Caution Refer to the Safety Information section before removing equipment covers or
connecting or disconnecting any signal wires.
To connect the signal to the terminal block, perform the following steps,
referring to Figures 1 and 2 as necessary:
1. Unscrew the top cover screws and remove the top cover.
2. Loosen the strain-relief screws and remove the strain-relief bar.
5 ±1 V
peak
or VDC 5 1
10 ±500 mV
peak
or VDC 10 1
20 ±250 mV
peak
or VDC 20 1
50 ±100 mV
peak
or VDC 50 1
100 ±50 mV
peak
or VDC 100 1
200 ±25 mV
peak
or VDC 200 1
250 ±20 mV
peak
or VDC 250 1
500 ±10 mV
peak
or VDC 500 1
1000 ±5 mV
peak
or VDC 1000 1
2000 ±2.5 mV
peak
or VDC 2000 1
Table 1. Input Signal Range Versus Gain (Continued)
Overall
Gain
Overall Voltage
Range
Module
Gain
Terminal
Block Gain