National Instruments SCXI-1126, User Manual, Page: 60 / 61

Index
© National Instruments Corporation I-3 SCXI-1126 User Manual
R
rear connector
continuous driving of pins (note), 1-5
pin assignments (figure), 2-7
SCXIbus to rear connector to DAQ board
pin equivalencies (table), 2-9
signal descriptions (table), 2-8
registers, digital control circuitry, 1-6
removing SCXI-1126
from Measurement & Automation
Explorer, 1-22
from SCXI chassis, 1-23
RSVD signal (table), 2-8
S
SCANCLK signal (table), 2-8
scanning, direct and indirect, 1-4
SCXI chassis
connecting SCXI-1126 to DAQ
device, 1-12
installing SCXI-1126, 1-10
removing SCXI-1126, 1-22
SCXI-1126
block diagram, 1-2
configuration and self-test, 1-14
configuration settings, 1-20
installation, 1-10
overview, 1-1
requirements for getting started, 1-7
software programming choices
National Instruments ADE
software, 1-9
NI-DAQ, 1-8
SCXIbus to rear connector to DAQ board pin
equivalencies (table), 2-9
self-test verification
steps for, 1-16, 1-18
troubleshooting, 1-19
SERCLK signal
description (table), 2-8
pin equivalencies (table), 2-9
SERDATIN signal
description (table), 2-8
pin equivalencies (table), 2-9
SERDATOUT signal
description (table), 2-8
pin equivalencies (table), 2-9
signal connections
front connector
AC coupled signal connections
(figure), 2-3
analog input channels, 2-1
floating AC signal connections
(figure), 2-3
floating signal connections
(figure), 2-2
ground-referenced signal
connections (figure), 2-2
pin assignments (table), 2-5
signal descriptions (table), 2-6
rear connector
pin assignments (figure), 2-7
SCXIbus to rear connector to DAQ
board pin equivalencies
(table), 2-9
signal descriptions (table), 2-8
SLOT0SEL* signal
description (table), 2-8
pin equivalencies (table), 2-9
software
application development environments
supported, 1-9
installation, 1-9
software programming choices
National Instruments application
software, 1-9
NI-DAQ, 1-8