Chapter 1
Installing and Configuring the SCXI-1126
1-22
ni.com
Threshold Level
To set the threshold level, complete the following steps:
1.
Select the channel(s) you want to configure for threshold level.
You can select blocks of channels by pressing the <Shift> key while
making the selections or individual channels by pressing the <Ctrl>
key while making the selections.
2.
Under the
Settings
tab, set the threshold level by entering the value in
the
Level
box.
3.
Repeat steps 1 and 2 until you have configured all the channels.
Threshold Hysteresis
To set the threshold hysteresis, complete the following steps:
1.
Select the channel(s) you want to configure for threshold hysteresis.
You can select blocks of channels by pressing the <Shift> key while
making the selections or individual channels by pressing the <Ctrl>
key while making the selections.
2.
Under the
Settings
tab, set the threshold hysteresis by entering the
value in the
Hysteresis
box.
3.
Repeat steps 1 and 2 until you have configured all the channels.
Removing the SCXI-1126
This section provides details for removing an SCXI-1126 module from an
SCXI chassis and for removing the SCXI-1126 module from MAX.
Removing the SCXI-1126 from Measurement & Automation Explorer
To remove a module from MAX, complete the following steps after
launching MAX:
1.
Display the list of installed devices and interfaces by clicking
the
+
next to the
Devices and Interfaces
icon. If the SCXI-1126 is
configured under
NI-DAQmx
, remove the module under
NI-DAQmx
Devices
. If the SCXI-1126 is configured under
Traditional NI-DAQ
,
remove the module under
Traditional NI-DAQ Devices
.
2.
Locate the chassis in the list of installed devices. Display the list of
modules in the chassis by clicking the
+
next to the
Chassis
icon.
3.
Right-click the module or chassis you want to delete and click
Delete
.
4.
You are presented with a confirmation window. Click
Yes
to continue
deleting the module or chassis or
No
to cancel this action.