NI RMC-8354 Installation Guide
10
ni.com
6.
Power on the NI RMC-8354.
7.
Verify that the NI RMC-8354 boots. If it does not boot, refer to the
What if the NI RMC-8354 does not boot?
section of Chapter 5,
Troubleshooting
, in the
NI RMC-8354 User Manual
.
Connecting Safety Ground
The NI RMC-8354 is designed with a three-position NEMA 5-15 style plug
for the U.S. that connects the ground line to the chassis ground. To
minimize shock hazard, make sure the electrical power outlet you use to
power the chassis has an appropriate earth safety ground.
Connecting to Power Source
Attach input power through the rear AC inlet using the appropriate
AC power cable supplied.
Caution
Overloading the circuits may damage supply wiring. Do not exceed the ratings on
the equipment nameplate when connecting equipment to the supply circuit.
Caution
To completely remove power, you
must
disconnect the AC power cable.
The power switch allows you to power on the chassis or place it in standby
mode. Push the power switch to the On position (if not already on). Observe
that all fans become operational and the power indicator is lit.
Rack Mounting
Note
The rack mount kit provided with the NI RMC-8354 is intended to work with racks
that are 26–33 in. deep. For information about installing the NI RMC-8354 into a rack that
is less than 26 in. deep, refer to KnowledgeBase 4GCEKKMT at
ni.com/support
.
The rack mounting hardware includes:
•
One pair of inner slides to be installed on the chassis.
•
One pair of outer slides to be installed in the rack.
•
Three pairs of short brackets for the outer slides.
•
Bag of assorted fasteners.
•
One pair of long brackets for the rear of the outer slides.
Caution
When mounting the equipment in the rack, do not create a hazardous condition
due to uneven mechanical loading.
