10. Power on the chassis.
Verifying Hardware Installation for Host Targets
You can verify that the system recognizes the NI PXIe-7857R by using Measurement &
Automation Explorer (MAX).
1.
Launch MAX by navigating to
Start
»
All Programs
»
National Instruments
»
MAX
or by
clicking the MAX desktop icon.
2.
Expand
Devices and Interfaces
.
3.
Verify that the device appears under
Devices and Interfaces
.
If the device does not appear, press <F5> to refresh the view in MAX. If the device does
not appear after refreshing the view, visit
for troubleshooting information.
Verifying Hardware Installation for Remote
Targets
You can verify that the system recognizes the NI PXIe-7857R by using Measurement &
Automation Explorer (MAX).
1.
Launch MAX on the host computer.
2.
Expand
Remote Targets
in the configuration tree and locate your system.
3.
Install LabVIEW Real-Time Module 2016 and NI RIO Device Drivers August 2016 or
later on your
Remote Target
.
a)
Refer to the
Installing Software on the Host Computer
section for information about
installing software on the host.
b)
Refer to the
PXI Express Controllers User Manual
for
information on installing software on the target.
4.
Under
Remote Targets
, find and expand
Devices and Interfaces
.
If the device does not appear, press <F5> to refresh the view in MAX. If the device does
not appear after refreshing the view, visit
for troubleshooting information.
NI PXIe-7857R Getting Started Guide
|
© National Instruments
|
5
