National Instruments PXIe-8100, User Manual

Page: 33 / 71

Chapter 2 Installation and Configuration
NI PXIe-8100 User Manual 2-18 ni.com
• Switch 3— Disable Startup VI : Set this switch to ON to prevent
VIs from automatically running at startup if the controller becomes
inaccessible because of a startup VI.
• Switch 4— Reset IP Address : Set this switch to ON to reset the
IP address and other TCP/IP settings to their factory defaults. Use this
switch if moving the controller to a different subnet or if the current
TCP/IP settings are valid.
Note By default, the target will automatically attempt to connect to the network using
DHCP. If the target is unable to initiate a DHCP connection, the target connects to the
network with a link-local IP address or
169.254.x.x
.
Figure 2-4 shows the location of the LabVIEW RT configuration switches.
The switches are shown in the OFF position.
Figure 2-4. LabVIEW RT Configuration Switches
1 S witch 1—Boot L ab VIEW RT
2 S witch 2—Boot Sa fe Mode
3 S witch 3 —Di sab le S t a rt u p VI
4 S witch 4—Re s et IP Addre ss
3
2
1
4