5.
Power on the chassis.
6.
Verify that the device appears in MAX.
7.
Reset the device in MAX and perform a self-test.
What Should I Do if the NI 5663E Doesn't Appear in MAX?
1.
In the MAX configuration tree, expand
Devices and Interfaces
.
2.
Expand the
Chassis
tree to see the list of installed hardware, and press <F5> to refresh
the list.
3.
If the module is still not listed, power off the system, ensure that all hardware is correctly
installed, and restart the system.
4.
Navigate to the Device Manager.
Operating System
Description
Windows 10/8.1
Right-click the Start button, and select
Device Manager
.
Windows 7
Select
Start
»
Control Panel
»
Device Manager
.
5.
If you are using a PXI or PXI Express controller, verify that a
National Instruments
entry appears in the
System Devices
list. Reinstall NI-RFSA and the module if error
conditions appear in the list. If you are using an MXI controller, right-click
PCI-to-PCI
Bridge
, and select
Properties
from the shortcut menu to verify that the bridge is enabled.
What Should I Do if the Module Fails the Self-Test?
1.
Restart the system.
2.
Launch MAX, and perform the self-test again.
3.
Power off the chassis.
4.
Reinstall the failed module in a different slot.
5.
Power on the chassis.
6.
Perform the self-test again.
Configuration
What Should I Do if the Device Does Not Initialize?
Failure to initialize may indicate a problem with module interconnections or with MAX. If the
niRFSA Initialize VI or the
niRFSA_init
function returns an error and the NI 5663E fails
to initialize, complete the following steps:
1.
Reconnect the NI 5663E hardware module front panel cables securely.
2.
Power on your system and run the MAX configuration and self-test procedures.
Related Information
Interconnecting the NI 5663E Modules
Configuring the NI 5663E in MAX
on page 18
24
|
ni.com
|
NI PXIe-5663E Getting Started Guide