© National Instruments
|
2-9
NI PXIe-1085 Series User Manual
3.
Install a module into a chassis slot by first placing the module card PCB into the front of
the card guides (top and bottom), as shown in Figure 2-6. Slide the module to the rear of
the chassis, making sure that the injector/ejector handle is pushed down as shown in
Figure 2-6.
4.
When you begin to feel resistance, push up on the injector/ejector handle to fully seat the
module into the chassis frame. Secure the module front panel to the chassis using the
module front-panel mounting screws.
Figure 2-6.
Installing PXI, PXI Express, or CompactPCI Peripheral Modules
Remote System Monitoring
The NI PXIe-1085 Series chassis provides an Ethernet port on the rear panel of the chassis. You
can use this Ethernet port to monitor the chassis operating parameters remotely over a network.
Refer to Figure 1-2,
Rear View of the NI PXIe-1085 Series Chassis
, to locate the Ethernet
connector.
The Ethernet port on the chassis supports communication speeds of 10 Mbps and 100 Mbps.
Contact your network administrator to determine whether your network supports DHCP. If your
network uses DHCP, the network configuration is performed automatically.
To use the remote monitoring interface, connect one end of an Ethernet cable to your
NI PXIe-1085 Series chassis. Connect the other end of the cable to your Ethernet network.
1
Injector/Ejector Handle
2
PXI Peripheral Module
3
Peripheral Module Front Panel Mounting Screws (2x)
4
NI PXI Express System Controller
5
NI PXIe-1085 Series Chassis
6
Injector/Ejector Rail
5
4
6
3
2
1
NI
PXI
e-1
085
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
