Chapter 2
Installation and Configuration
2-4
ni.com
Figure 2-2 shows an NI PXI-8101 installed in the system controller slot of
a National Instruments PXI-1036 chassis. You can place PXI devices in any
other slots. An NI PXI-8102 would appear the same installed in the chassis.
Figure 2-2.
NI PXI-8101 Controller Installed in a PXI Chassis
How to Remove the Controller from the PXI Chassis
The NI PXI-8101/8102 controller is designed for easy handling. To remove
the unit from the PXI chassis, complete the following steps:
1.
Power off the chassis.
2.
Remove any cables that may be attached to the controller front panel.
3.
Unscrew the bracket-retaining screws in the front panel. Refer to
Figure 2-1 for the location of these screws.
4.
Press the injector/ejector handle down.
5.
Slide the unit out of the chassis.
1
NI PXI-1036 Ch
ass
i
s
2
NI PXI-8101 Controller
3
Injector/Ejector R
a
il
1
3
2
NI P
XI
-1036