Figure 2.
sbRIO-9627 Components
1
16
15
15
19
18
17
14
14
12
2
3
4
5
6
7
8
9 10
11
20
13
13
1. W3, RS-485 (COM3)
2. W4, RS-232 (COM2)
3. J6, SDHC
4. J9, Power Connector
5. Chassis Ground Bracket
6. J10, USB Host Port
7. W1, CAN (CAN0)
8. J7, RJ-45 Ethernet Port
9. W2, RS-232 (COM1)
10. Reset Switch
11. LEDs
12. J5, MIO
13. Mounting Holes Connected to Chassis Ground
14. Ethernet RGMII Transceiver
15. ULPI USB Transceiver
16. FPGA Processor
17. DDR Memory
18. NAND Flash
19. CPLD
20. J1, RIO Mezzanine Card Connector
Connecting the sbRIO-9627 to Power
The NI sbRIO device requires a 9 VDC to 30 VDC external power supply. The NI sbRIO
device filters and regulates the supplied power and provides power for RMCs.
Note
Refer to the
Power Requirements
section of the
NI sbRIO-9627
Specifications
for the complete power requirement specifications.
Note
Refer to the
Power Requirements
section of the
NI sbRIO-9627 User Manual
for formulas and examples for calculating power requirements for different
configurations and application types.
Note
Refer to the
Power Requirements
section of the
NI sbRIO-9627 User Manual
for proper wiring of the power cable assembly.
Complete the following steps to connect a power supply to the device.
Caution
Do not mate or unmate the power supply connectors while power is
applied.
1. Ensure that your power supply is powered off.
2. Insert the power connector plug into the power connector receptacle of the NI sbRIO
device until the connector latches into place.
NI sbRIO-9627 Getting Started Guide
|
© National Instruments
|
5
Summary of Contents for NI sbRIO-9627
Page 1: ...sbRIO 9607 ...
