National Instruments NI Real-Time Hypervisor, Quick Start Manual

Page: 5 / 8

© National Instruments Corporation 5 NI Real-Time Hypervisor 2.10 Quick Start Guide
NIHypervisorManager
application to launch the NI Real-Time Hypervisor Manager.
A dialog box appears and prompts you to run the setup.
19. Click the Run Setup button. The NI Real-Time Hypervisor manager runs the setup and
prompts you to restart the system.
20. Restart the system and select Linux from the boot menu.
21. Log in with root privileges.
22. Compile the virtualization drivers into the Linux kernel. Refer to
Virtualization_Drivers.pdf
and to
Virtualization_Drivers_Supplement.txt
, located in the
/usr/local/natinst/
hypervisor
directory, for instructions to perform this task. Pay particular attention to the
supplementary text file for information about the correct commands and file paths you need
when compiling the virtualization drivers. The
linux-drv-src.tgz
file, which contains
the virtualization drivers, is located in the
/usr/local/natinst/
hypervisor/system/drivers
directory
.
23. Navigate to the
/usr/local/natinst/nihypshm
directory and run
KernelDrv_Install.sh
.
24. Refer to the Getting Started with Your NI Real-Time Hypervisor System section below for
instructions to partition your devices according to your application needs and begin
developing applications.